A un vistazo
Physical Port
24-port 10/100BASE-TX RJ45 copper with IEEE 802.3at/af PoE+ injector
2-port 10/100/1000BASE-T Gigabit RJ45 copper
2 1000BASE-X mini-GBIC/SFP slots, shared with port-25 to port-26
RJ45 console interface for switch basic management and setup
Reset button for system factory default
Switching
Hardware-based 10/100Mbps, half/full duplex and 1000Mbps full duplex mode, flow control and auto-negotiation, and auto MDI/MDI-X
Features Store-and-Forward mode with wire-speed filtering and forwarding rates
IEEE 802.3x flow control for full duplex operation and back pressure for half duplex operation
Automatic address learning and address aging
Supports CSMA/CD protocol
Power over Ethernet
Complies with IEEE 802.3at Power over Ethernet Plus
Complies with IEEE 802.3af Power over Ethernet
Up to 24 ports of IEEE 802.3af/802.3at devices powered
Supports PoE Power up to 30 watts for each PoE port
240-watt PoE budget
Auto detects powered device (PD)
Circuit protection prevents power interference between ports
Remote power feeding up to 250m via extend mode
PoE Management
Per port PoE function enable/disable
Per Port PoE operation mode selection
Per PoE port power budget control
PD classification detection and PoE consumption usage status
Intelligent PoE features
PD alive check
PoE port sequence
PoE schedule
Layer 2 Features
Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)
High performance Store and Forward architecture, runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
Supports VLAN
Port-based VLAN, up to 26 VLAN groups
IEEE 802.1Q tagged VLAN
Protocol VLAN
Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
GVRP
Voice VLAN
Supports Spanning Tree Protocol
STP (IEEE 802.1D Spanning Tree Protocol)
RSTP (IEEE 802.1w Rapid Spanning Tree Protocol)
MSTP (IEEE 802.1s Multiple Spanning Tree Protocol)
STP BPDU Filtering, BPDU Protect
Supports Link Aggregation
IEEE 802.3ad Link Aggregation Control Protocol (LACP)
1 LACP group, up to 2 ports per LACP group
Cisco ether-channel (static trunk)
1 trunk group, up to 2 ports per trunk group
Provides port mirror (many-to-1)
Loop detection
Quality of Service
Ingress/Egress Rate Limit per port bandwidth control
Storm Control support
Broadcast/ Multicast /DLF (Destination Lookup Fail)/ARP/ICMP
Traffic classification
IEEE 802.1p Qos/CoS
TCP/UDP/DSCP/IP precedence of IPv4/IPv6 packets
Strict priority and Weighted Round Robin (WRR) CoS policies
Multicast
Supports IPv4 IGMP snooping v1/ v2 and v3
Supports IPv6 MLD snooping v1, v2
Security
Access Control List
IPv4/IPv6 IP-based ACL
MAC-based ACL
Port-MAC-IP Address Binding
Port-MAC-IP Port Setting
Port-MAC-IP Entry Setting
MAC Address Binding
Static MAC
MAC Filtering
DHCP snooping to filter distrusted DHCP messages
ARP Inspection discards ARP packets with invalid MAC address to IP address binding
Detalles del producto
Preguntas y respuestas sobre este producto
Aún no hay preguntas acerca de este producto
Resuelve tus dudas preguntando a la comunidad y a nuestro equipo de servicio al cliente.
Resuelve tus dudas preguntando a la comunidad y a nuestro equipo de servicio al cliente.
Especificaciones
| Puertos e Interfaces | |
|---|---|
| Cantidad de puertos básicos de conmutación RJ-45 Ethernet | 26 |
| Puertos tipo básico de conmutación RJ-45 Ethernet | Gigabit Ethernet (10/100/1000) |
| Transmisión de datos | |
|---|---|
| Capacidad de conmutación | 8 Gbit/s |
| Tabla de direcciones MAC | 4000 entradas |
| Alimentación a través de Ethernet (PoE) | |
|---|---|
| Presupuesto total de potencia PoE | 220 W |
| Energía sobre Ethernet (PoE) |
|
| Características de administración | |
|---|---|
| Tipo de interruptor | Gestionado |
Regresar arriba ▲
100% Productos nuevos 
